Tycon Systems Support | Knowledge Base

Popular Articles
What changes should I make to the EZ-Bridge when changing to a Multipoint system?
The EZ-Bridge ships from the factory configured as a Point-to-Point system. Sometimes people need to create a multipoint system where there is one Access Point and multiple client antennas. One application might be connecting several buildings ...
How do I determine runtime if the batteries aren’t at 100% charge?
To determine the runtime of a battery system given its power consumption, voltage, and a discharge cut-off voltage of 11V, use the formula: Runtime (hours) = (Battery Capacity (Ah) * (Starting Voltage – Cut-off Voltage)) / Power Consumption (W); ...
IP address changes when factory resetting the TP-MS616
The TP-MS616 IP address comes shipped with the IP address set to 192.168.1.10 as default. If you ever do a factory reset on this device, the IP address will change to 192.168.2.1. It is important to change the IP address back to 192.168.2.10 after ...
How do I enter the console on the TP-SW8GBT/AT/PSV-U PoE Switch?
Why is my MPPT controller shutting the load off automatically?
Our MPPT charge controllers have a built-in low or high voltage cut off, which protects the batteries and keeps them healthy for longer run times. One of the features the MPPT controllers have the ability to shut off during low voltage times (11VDC) ...

Recent Articles
Why Are Wide-Temp Lithium Batteries Worth the Investment?
Switching from traditional lead-acid to Tycon’s Wide Temperature LiFePO₄ batteries doesn’t just improve performance—it saves money over time. Here's how they compare: Feature Lead-Acid Battery Tycon Wide-Temp Lithium Usable Capacity (%) ~50% 90–100% ...
I'm having trouble accessing the TP-SW8GAT/24-SFP or TP-SW8GAT/BT/24-SFP console port
Some USB to serial cables available online won't work properly with the Tycon Switches. Cables with FTDI or Prolific chips will work fine. If the vendor doesn't specify the chipset, we suggest you don't buy the serial cable. We've successfully tested ...
Turning the load on/off (TS-MPPT models)
To turn the load on or off, first you need to press the silver button until you see the load information screen as seen below: When on this screen, hold the silver button down for 3 seconds and the load will turn on or off depending on what state the ...
Can I add a solar panel to a UPSPro system?
Yes, you can do this but it is important to include a blocking or a one directional diode in series with the positive lead of the solar panel. The solar controller will always charge the batteries using the source providing the higher voltage, so if ...
What port do I put the main antenna in?
The Mobile Main antenna connector is the far outside port, the other port is the mobile AUX antenna connector.

Popular Articles