Where can I get those green wire terminal connectors?

• Related Articles

• Where can I get the replacement green connectors for my Tycon PoE Products?

  The following shows sources for 4 pole green connectors: For different pole counts, just follow the manufacturers series. Tycon uses Howder Taiwan connectors. HD-515H-4P “http://www.howder-tw.com/admin/upload/HD-515H.pdf“ These connectors from On ...

• What does the VIN1+, VIN2+, VIN-, and FG mean on my DC to DC converter?

  VIN1+ and VIN2+ are used to power the device using 2 different sources. VIN- is there the negative wire connects to. FG is your chassis ground.

• How do I control the PoE ports on my TP-SWxG-2SFP PoE switch using SNMP?

  The TP-SW4G-2SFP and TP-SW8G-2SFP are fully manageable PoE switches. You can turn the PoE ports on and off through SNMP. Requirement: Firmware must be V2.1 or newer. You can get the latest firmware at tyconsystems.com on the support page. MIB files ...

• What do the LEDs on the TP-DCDC-1256GD-VHP indicate?

  The TP-DCDC-1256GD-VHP has two separate 802.3at output detectors. One on pins 1,2,3,6 and the other on pins 4,5,7,8. Each detector has an LED associated with it. If the LED is green, it means that the unit had a successful 802.3at detect on the pins ...

• I was updating the firmware on the TPDIN-Monitor-WEB3 and now I can’t access the unit?

  A communications problem during upgrade may have caused corruption in the flash memory or the “Upgrade and Reboot” button was double clicked or pressed twice. Follow these steps to recover: Press and hold the reset button while powering up the unit. ...