What hardware comes in my TPSM-80×4-UNI solar mount? The hardware included in the TPSM-80×4-UNI is as follows:
This mount can support up to 4 panels and can be configured for a 2-panel and 4-panel set up. It will come with a guide to walk you through set up, as well as the bolts, framework, hose clamps, and fasteners for the panel attachment.
Related Articles
RemotePro® and UPSPro® Troubleshooting
Minimum Equipment Needed: Good digital voltmeter which will display DC Volts for Battery Voltage. Measure battery voltage at the charger/controller System Voltage Expected Battery Voltage (charging Expected Battery Voltage (not-charging12V – 13.5VDC ...
RemotePro® and UPSPro® Battery Care
RemotePro® and UPSPro® systems are designed to maintain proper battery charge within a defined range. Our systems have protections for over-discharge of batteries but batteries also self-discharge over time, so if they are left without any charge or ...
Grounding a RemotePro and UPSPro system
Grounding our solar systems aren’t required. As long as the mounting pole is grounded, it is okay. If mounting a system to a pole or a location that isn’t properly grounded, it is recommended to install a grounding rod and wire for the system. Over ...
How to calculate how many solar panels/solar panel wattage is needed to support my equipment?
We have a free system requirements calculator located at: https://tyconsystems.com/tycon-support/tycon-calculators/ You can use the online calculator or follow the guide below to determine solar requirements. First calculate the total watts required ...
Can I lengthen the cable between the solar controller and the solar panels?
Most of the Tycon RemotePro® systems come with a 20′ 12AWG cable. Sometimes a customer may want to mount the solar panels at a different location than the solar controller/batteries. This can be done as long as you understand that if you extend the ...