What do the LEDs on the TP-DCDC-1256GD-VHP indicate?
The TP-DCDC-1256GD-VHP has two separate 802.3at output detectors. One
on pins 1,2,3,6 and the other on pins 4,5,7,8. Each detector has an LED
associated with it. If the LED is green, it means that the unit had a
successful 802.3at detect on the pins and those pins are powered up.
Normal operation would be two green LEDs.
Related Articles
How do I factory reset the TP-MS616, TP-MS308, TP-MS316, TP-MS324?
Turn off the unit, disconnect any Ethernet cables attached to the module. Open the unit and locate the reset button. This can be found one of two different spots: Spot 1: Located on the lower left of the module in the corner Spot 2: Located on right ...
NTP Time not Working or updating on my TP-SW4G-2SFP and TP-SW8G-2SFP
Sometimes the date and time of the TP-SW4G-2SFP and TP-SW8G-2SFP are not updating automatically. This is usually caused by the switch not having the proper IP route to connect to the NTP server. First, you need to program the switch to have an IP ...
How do I control the PoE ports on my TP-SWxG-2SFP PoE switch using SNMP?
The TP-SW4G-2SFP and TP-SW8G-2SFP are fully manageable PoE switches. You can turn the PoE ports on and off through SNMP. Requirement: Firmware must be V2.1 or newer. You can get the latest firmware at tyconsystems.com on the support page. MIB files ...
Can I use two or more units of the TP-SW4G-2SFP / TP-SW8G-2SFP in the same network?
Yes, you can use two or more units of the TP-SW4G-2SFP / TP-SW8G-2SFP / TP-SW8GAT/BT/24-SFP / TP-SW8GAT/24-SFP in the same network. If for any reason, using two or more of those switches causes problems with your SNMP software or your network, please ...
How do I control the PoE ports on my TP-SW4G-2SFP or TP-SW8G-2SFP managed PoE switch using SSH?
TP-SW4G-2SFP, TP-SW8GAT/BT/24-SFP, TP-SW8GAT/24-SFP and TP-SW8G-2SFP Managed PoE Switches PoE Port Control Using SSH: You can use an SSH capable terminal program such as Putty. “https://www.putty.org/” To access the switch through any of the RJ45 ...