What do the error codes in the log file mean?
If it is a mail send error code, you can see a list here:
Common problems that cause SMTP errors are:
1. No valid gateway or DNS entered in the Network Settings page
2. Incorrect SMTP server settings in Alert Email Setup page
Related Articles
How can I reset my TPDIN® product to factory defaults?
TPDIN-Monitor-WEB: Hold down the reset button while powering up the TPDIN-Monitor-WEB and hold for 15 seconds then release reset button. This should set the unit back to factory defaults. Note: Resetting to factory defaults doesn’t affect the IP ...What does the log entry “System Init *V2.3.5 WDT was triggered” mean?
The TPDIN2 rebooted via a power cycle or a software reboot. Note: V2.3.5 is the firmware version of your TPDIN2.Communicating with TPDIN-Monitor-WEB via TELNET
NOTE: This only works with the original TPDIN-MONITOR-WEB. It is not implemented in the newer TPDIN-MONITOR-WEB2. You can use the ability of telnet to connect to the TPDIN-Monitor-WEB TCP port and use the HTTP interface to control the unit. Connect ...I cannot send email from my TPDIN® series product!
Following are the existing TPDIN products and what type of SMTP they support: TPDIN-Monitor-WEB Non SSL – Port 25 TPDIN-Monitor-WEB2 Non SSL – Port 25 ; SSL – Port 465 TPDIN-Monitor-WEB3 Non SSL – Port 25 ; TLS – Port 587 TPDIN-SC48-20 V1 Non SSL – ...How many characters for username and password in the TPDIN® products?
TPDIN-Monitor-WEB: username and password fields on the Network Page accept up to 10 characters. TPDIN-Monitor-WEB2: username and password can accept up to 20 characters. TPDIN-Monitor-WEB3: username and password can accept up to 24 characters. ...