What changes should I make to the EZ-Bridge when changing to a Multipoint system?

What changes should I make to the EZ-Bridge when changing to a Multipoint system?

Applicable Models:
EZBR-DUAL-AC
EZBR-0214+

The EZ-Bridge ships from the factory configured as a Point-to-Point system.

Sometimes people need to create a multipoint system where there is one Access Point and multiple client antennas. One application might be connecting several buildings together using a single access point and multiple clients.

The following changes should be made if changing EZBR-DUAL-AC/ and EZBR-0214+ Point to Multipoint:
  1. Reset AP to Factory Default
  2. Change Mode of 802.11AC interface to Access Point instead of Access Point (WDS)
  3. Uncheck the Hide ESSID option
  4. Set ESSID to your custom ESSID. Each AP must have a different ESSID
  5. Set Wireless Security Key to your custom key/passphrase
  6. Set Wireless channel to a fixed channel (Frequency) Each AP must use a different channel.
  7. Set all units on a different static IP
  8. Reset Client to factory default
  9. Change mode of client to Client, not Client(WDS)
  10. Set ESSID to match the ESSID of the AP
  11. Set wireless security key to match key of the AP

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • What changes are required to the EZ-Bridge setup to get the system up and running?

      Applicable Models: All EZ-Bridge models Please be aware that typically, no changes are required to get the units running and create a wireless bridge. Our EZ-Bridges are designed as plug-and-play units. All that is needed is to power the units up, ...

    • My EZ-Bridge was working but now it keeps dropping connection or performance has degraded. What could be the problem?

      Applicable Models: All EZ-Bridge models If your system was working but now seems to be sluggish or it is dropping connection, the most likely culprit is that a new wireless device was added to your environment and there is wireless interference ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...

    • How do I connect an EZGO+ to my EZ-Bridge LT+?

      Applicable models: EZBR-LT+ EZBR-LT2+ EZBR-LT5+ EZGO+ EZGO-2+ EZGO-5+ There are 2 main requirements so you can have another receiver in your EZ-Bridge LT+ setup. Make sure the 2nd receiving antenna would be within a 35-degree beamwidth of the ...