What changes are required to the EZ-Bridge setup to get the system up and running?

• Related Articles

• EZ-Bridge LT+ TyconOS Wiki

  The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

• Do I need to be an engineer or technical person to install and operate the EZ-Bridge?

  Applicable Models: All EZBR models The EZ-Bridge® is plug and play with no setup required. If you can install a wireless router or computer peripheral, you should have no problem with the EZ-Bridge.

• How do I use the EZ-Bridge as a Wi-Fi access point?

  Applicable Models: All EZ-Bridge models If you need wireless access at the installation point: Start by making changes on the remote unit (Unit B). Switch the mode from “Station (WDS)” to “Station”. Do this by going to: Network >> Wi-Fi >> Edit >> ...

• Can I have a router on both sides of the EZ-Bridge® link?

  Applicable models: EZBR-0214+ EZBR-5AC EZBR-DUAL-AC EZGO-0214+ EZGO-5AC EZGO-DUAL-AC Yes, on the internet side of the link, the EZ-Bridge® would be connected to one of the LAN ports on the main router. On the remote side of the link the EZ-Bridge® ...

• My EZ-Bridge was working but now it keeps dropping connection or performance has degraded. What could be the problem?

  Applicable Models: All EZ-Bridge models If your system was working but now seems to be sluggish or it is dropping connection, the most likely culprit is that a new wireless device was added to your environment and there is wireless interference ...