How tight should the terminal screws on my MPPT controller be?

• Related Articles

• How do I connect my TP-SW8GBT/AT/PSV-U or TP-SW16GBT/AT/PSV-U Switch to the Tycon MPPT Solar Controller?

  Applicable to the following products: TP-SW8GBT/AT/PSV-U TP-SW16GBT/AT/PSV-U TS-SC24-40N-MPPT TS-SC24-60N-MPPT TS-SC48-60P-MPPT TP-SC24-30N-MPPT TP-SC24-40N-MPPT Tycon manageable PoE Switches such as the TP-SW8GBT/AT/PSV-U and TP-SW16GBT/AT/PSV-U can ...

• Can I lengthen the cable between the solar controller and the solar panels?

  Applicable systems: All RemotePro systems Most Tycon RemotePro® systems come with a 20′ 12AWG cable, though you can also order a 60' cable for your system (part number: RPST-CABLE60-Conn). Sometimes a customer may want to mount the solar panels at a ...

• How can I add a grid or generator powered battery charger to my RemotePro system with MPPT solar controller?

  Applicable Systems: All RemotePro systems: The following wiring diagram shows how to add an AC powered battery charger to the RemotePro system to provide supplemental charging of the batteries.

• Why does the load output of my solar controller keep shutting down?

  Applicable systems: All RemotePro, UPSPro, and MobileSolarPro systems There are a couple reasons why the load output on the controller will turn off. 1. If the batteries get too low (11.1V for 12V battery, 22.2V for 24V battery, or 44.4V for 48V ...

• I have my system hooked up but I’m not getting the correct voltage out of the controller, what’s wrong with it?

  Applicable Models: All RemotePro, UPSPro, and MobileSolarPro systems. The two most common causes of incorrect output voltage are having loose or incorrect wire connections, or using a charge controller that was designed for a different application. ...