Status page explanation for the EZ-Bridge® (EZBR-0214+ and EZBR-DUAL-AC)

Status page explanation for the EZ-Bridge® (EZBR-0214+ and EZBR-DUAL-AC)

Applicable models:
EZBR-0214+
EZBR-DUAL-AC
EZGO-0214+
EZGO-DUAL-AC 

The EZBR-0214+ and the EZBR-DUAL-AC use the same firmware and have the same status page.  Below you will find descriptions of each bar that  will make it easier to understand. This is only for the applicable models mentioned before.

Note: The status page will only show up on the client side of the bridge.
 
EZ-Bridge®

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • Can the EZ-Bridge® be used with VLANs?

      Products: EZBR-0214+ EZBR-DUAL-AC EZBR-5AC EZBR-DUAL-AC+ The EZ-Bridge® creates a layer 2 bridge between two points. The EZ-Bridge® will pass all untagged VLAN packets. The EZ-Bridge is not compatible with VLAN Trunking or VLAN Tagged Frames. The new ...

    • Can I power your EZ-Bridge products from a standard PoE Switch?

      Applicable models: EZBR-DUAL-AC EZ-Bridge LT+ EZ-Bridge HD EZ-Bridge ULTRA It depends on the model: EZBR-Dual-AC can be powered from a standard PoE Switch which is 48V PoE. The EZ-Bridge LT+, HD, and ULTRA require 15V to 24V Passive PoE The EZ-Bridge ...

    • Can I have a router on both sides of the EZ-Bridge® link?

      Applicable models: EZBR-0214+ EZBR-5AC EZBR-DUAL-AC EZGO-0214+ EZGO-5AC EZGO-DUAL-AC Yes, on the internet side of the link, the EZ-Bridge® would be connected to one of the LAN ports on the main router. On the remote side of the link the EZ-Bridge® ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...