How do I connect an EZGO+ to my EZ-Bridge LT+?

How do I connect an EZGO+ to my EZ-Bridge LT+?

Applicable models:
EZBR-LT+
EZBR-LT2+
EZBR-LT5+
EZGO+
EZGO-2+
EZGO-5+

There are 2 main requirements so you can have another receiver in your EZ-Bridge LT+ setup.

  1. Make sure the 2nd receiving antenna would be within a 35-degree beamwidth of the transmitting antenna (side A) if you have the EZ Bridge LT2+, or a 25-degree beamwidth for the EZ Bridge LT5+.
  2. You would need to use an EZ GO+ that matches the frequency of your EZ Bridge. EZ GO 2+ for EZ Bridge LT2+, EZ GO 5+ for EZ Bridge LT5+.

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How do I set up the EZ-Bridge-LT+?

      Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...

    • Can I power a second device off my EZ-Bridge-LT+?

      Applicable models: EZBR-LT+ The RJ45 connectors on the LT+ don’t have PoE output capability, but you can use a 5.5 x 2.1mm DC Plug Jumper to power up the second EZ-Bridge. Maximum 10W output @ 15-24V DC. Note: The EZ-Bridge requires much less than ...

    • Can I power your EZ-Bridge products from a standard PoE Switch?

      Applicable models: EZBR-DUAL-AC EZ-Bridge LT+ EZ-Bridge HD EZ-Bridge ULTRA It depends on the model: EZBR-Dual-AC can be powered from a standard PoE Switch which is 48V PoE. The EZ-Bridge LT+, HD, and ULTRA require 15V to 24V Passive PoE The EZ-Bridge ...

    • Can I have a router on both sides of the EZ-Bridge® link?

      Applicable models: EZBR-0214+ EZBR-5AC EZBR-DUAL-AC EZGO-0214+ EZGO-5AC EZGO-DUAL-AC Yes, on the internet side of the link, the EZ-Bridge® would be connected to one of the LAN ports on the main router. On the remote side of the link the EZ-Bridge® ...