Why can’t I open the EZ-Bridge® unit’s web page with my browser?

Why can’t I open the EZ-Bridge® unit’s web page with my browser?

Applicable Models:
All EZ-Bridge Models

To open the EZ-Bridge® web page with your browser you need to type in the IP address of the EZ-Bridge® into the address bar of a web browser (like Firefox, Chrome, etc.). Your computer must be on the same subnet as the EZ-Bridge®. If the EZ-Bridge® IP address is 192.168.1.139, your computers IP address must be on the same 192.168.1.xxx subnet. You can reset your computer’s IP address through your windows network control panel. After you access the EZ-Bridge® web control panel you can set the EZ-Bridge® to a fixed IP address so you always know where it is located on your network.

Note: No duplicate IP addresses can exist on a network. Tycon has developed a discovery tool to help you find the IP address of the EZ-Bridge® on your network.  You can find the Discovery tool for your model on the TyconSystems.com support here: https://tyconsystems.com/tycon-support/tycon-firmware/tyconos-discovery-tool/

    • Related Articles

    • How do I access the EZ-Bridge® to change settings?

      Applicable Models: All EZ-Bridge Models The EZ-Bridge® comes from the factory programmed to be plug and play. If the units are installed and powered up, they will automatically bridge the networks. If you want to change settings for any reason, you ...

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...

    • How to change the transmit channel on an EZ-Bridge Ultra?

      Applicable models: EZ-Bridge Ultra To Change transmitter frequency, open the Unit A Access Point Web Control Panel. Navigate to Wireless tab and change frequency to a fixed frequency rather than “Auto”. The Unit B Client will follow automatically ...

    • How can I secure SSH and Telnet on the EZ-Bridge?

      Applicable Models: All EZ-Bridge models If you want to tighten the security of accessing the EZ-Bridge unit through a terminal program like SSH or Telnet, we recommend the following: Set the listening port to a custom port. Any port other than 22 or ...