How to change the transmit channel on an EZ-Bridge Ultra?

• Related Articles

• EZ-Bridge LT+ TyconOS Wiki

  The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

• How do I turn on ping watchdog to automatically reboot the EZ-Bridge Ultra antennas?

  Applicable Models: EZ-Bridge Ultra Navigate to the Services Page. Enable Ping Watchdog and enter the IP address of the other antenna into the “IP Address to ping” field. Do this for both antennas. The result will be if the antennas lose connection ...

• My EZ-Bridge was working but now it keeps dropping connection or performance has degraded. What could be the problem?

  Applicable Models: All EZ-Bridge models If your system was working but now seems to be sluggish or it is dropping connection, the most likely culprit is that a new wireless device was added to your environment and there is wireless interference ...

• How do I access the EZ-Bridge® to change settings?

  Applicable Models: All EZ-Bridge Models The EZ-Bridge® comes from the factory programmed to be plug and play. If the units are installed and powered up, they will automatically bridge the networks. If you want to change settings for any reason, you ...

• How can I connect two separate networks across an EZ-Bridge Ultra?

  Applicable models: EZ-Bridge Ultra It is possible to have two separate networks connected through the EZ-Bridge Ultra You can have an EZ-Bridge Ultra connecting a network at the Local side with a network at the Remote side, using two routers, one ...