How many IP Cameras can I use with my EZ-Bridge LT2+ or LT5+ wireless link?

How many IP Cameras can I use with my EZ-Bridge LT2+ or LT5+ wireless link?

Applicable Models:
EZ-Bridge-LT+
EZ-Bridge-LT2+
EZ-Bridge-LT5+

The EZ-Bridge LT+ can support up to 100Mbps bandwidth. Normally people will see around 80Mbps due to RF interference or electrical noise or multi-path issues which cause packet retries and affect the overall throughput across the wireless bridge.

We have found a handy calculator online which can help you figure out the bandwidth you require for the IP cameras that you are using. You will need to know technical information about your IP Camera such as Compression type, Frames per second, Megapixel, etc.


If your total required bandwidth is less than what the EZ-Bridge LT+ can supply, it should work out well for you.

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...

    • How do I connect an EZGO+ to my EZ-Bridge LT+?

      Applicable models: EZBR-LT+ EZBR-LT2+ EZBR-LT5+ EZGO+ EZGO-2+ EZGO-5+ There are 2 main requirements so you can have another receiver in your EZ-Bridge LT+ setup. Make sure the 2nd receiving antenna would be within a 35-degree beamwidth of the ...

    • How do I set up the EZ-Bridge-LT+?

      Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...

    • Can I power a second device off my EZ-Bridge-LT+?

      Applicable models: EZBR-LT+ The RJ45 connectors on the LT+ don’t have PoE output capability, but you can use a 5.5 x 2.1mm DC Plug Jumper to power up the second EZ-Bridge. Maximum 10W output @ 15-24V DC. Note: The EZ-Bridge requires much less than ...