How do I use the EZ-Bridge as a Wi-Fi access point?
Applicable Models:
All EZ-Bridge models
If you need wireless access at the installation point:
- Start by making changes on the remote unit (Unit B).
- Switch the mode from “Station (WDS)” to “Station”.
- Do this by going to: Network >> Wi-Fi >> Edit >> Scroll down to Interface Configuration >> General Setup
Related Articles
EZ-Bridge LT+ TyconOS Wiki
The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...
My EZ-Bridge was working but now it keeps dropping connection or performance has degraded. What could be the problem?
Applicable Models: All EZ-Bridge models If your system was working but now seems to be sluggish or it is dropping connection, the most likely culprit is that a new wireless device was added to your environment and there is wireless interference ...
How do I set up the EZ-Bridge-LT+?
Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...
How do I access the EZ Bridge’s Web Interface?
You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...
How can I determine if my EZ-Bridge antenna system is working?
Applicable Models: All EZ-Bridge models There are different ways on checking if your EZ Bridge is working. After following the instruction manual on setting up the EZ Bridge, you may check if the EZ Bridge is working by: Checking the LED lights at ...