How do I turn on ping watchdog to automatically reboot the EZ-Bridge Ultra antennas?

How do I turn on ping watchdog to automatically reboot the EZ-Bridge Ultra antennas?

Applicable Models:
EZ-Bridge Ultra

  1. Navigate to the Services Page.
  2. Enable Ping Watchdog and enter the IP address of the other antenna into the “IP Address to ping” field.
  3. Do this for both antennas.
The result will be if the antennas lose connection with each other, they will both reboot and re-establish the connection.

Note: If the IP addressing of your antennas is set for DHCP, the IP address could change and then the ping watchdog will continually reboot the antennas. You really must have static IP Addresses for this to work.

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...

    • How to change the transmit channel on an EZ-Bridge Ultra?

      Applicable models: EZ-Bridge Ultra To Change transmitter frequency, open the Unit A Access Point Web Control Panel. Navigate to Wireless tab and change frequency to a fixed frequency rather than “Auto”. The Unit B Client will follow automatically ...

    • How can I connect two separate networks across an EZ-Bridge Ultra?

      Applicable models: EZ-Bridge Ultra It is possible to have two separate networks connected through the EZ-Bridge Ultra You can have an EZ-Bridge Ultra connecting a network at the Local side with a network at the Remote side, using two routers, one ...

    • Can I power your EZ-Bridge products from a standard PoE Switch?

      Applicable models: EZBR-DUAL-AC EZ-Bridge LT+ EZ-Bridge HD EZ-Bridge ULTRA It depends on the model: EZBR-Dual-AC can be powered from a standard PoE Switch which is 48V PoE. The EZ-Bridge LT+, HD, and ULTRA require 15V to 24V Passive PoE The EZ-Bridge ...