How do I reconfigure my EZBR-0214+ for side A and B firmware

How do I reconfigure my EZBR-0214+ for side A and B firmware

If you accidentally erased the firmware on your bridge you can visit Click here in order to get the side A and B firmware.

When you download the firmware to a computer you will need to open the antenna A GUI. You can get to it by connecting side A to your network and using our Tycon Discovery Tool to load into the GUI.  Go to System and then down to Backup/Flash Firmware.

 

.

 

You will need to uncheck the box “keep settings”, and then browse the files on your folder for the configuration file A.

 

Once you flash the firmware, it will install and reboot.  This can take a few minutes, and then you will need to repeat the process on side B.


    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active Wifi and Lan interfaces. ...

    • Status page explanation for the EZ-Bridge® (EZBR-0214+ and EZBR-DUAL-AC)

      The EZBR-0214+ and the EZBR-DUAL-AC use the same firmware and have the same status page. Below you will find descriptions of each bar that will make it easier to understand. This is only for the applicable models mentioned before. Note: The status ...

    • Can the EZ-Bridge® be used with VLANs?

      Products: EZBR-0214+ EZBR-DUAL-AC EZBR-5AC EZBR-DUAL-AC+ The EZ-Bridge® creates a layer 2 bridge between two points. The EZ-Bridge® will pass all untagged VLAN packets. The EZ-Bridge is not compatible with VLAN Trunking or VLAN Tagged Frames. The new ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...

    • How do I set up the EZ Bridge?

      EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and Play” Some package ...