How do I access the EZ-Bridge® to change settings?

How do I access the EZ-Bridge® to change settings?

The EZ-Bridge® comes from the factory programmed to be plug and play.

If the units are installed and powered up, they will automatically bridge the networks.  If you want to change settings for any reason, you should refer to the user guide that came with the unit. If you can’t find the user guide, you can download the latest user guide on the product pages on tyconsystems.com: https://tyconsystems.com/tycon-support/tycon-documentation/

The EZ-Bridge® has an embedded web control panel which is accessible via any web browser.

In order to access the web control panel, the computer IP address must be on the same subnet as the EZ-Bridge® IP address.

The EZ-Bridge® comes with DHCP enabled at the factory.

What this means is the EZ-Bridge will get it’s IP address from your router, if available. If the DHCP server is not available, the EZ-Bridge® will default to 192.168.1.139 and 192.168.1.239.

(Please note that the units will only attempt to get an IP address via DHCP upon power-up, so a power cycle will solve most problems with DHCP. Always cycle the power on the unit closest to the router first, wait two minutes and then power cycle the remote unit.)

Tycon offers a free Discovery tool that will help you find the unit’s IP Address on your network.

You can find the Discovery tool for your model at tyconsystems.com on the Support page here:

https://tyconsystems.wpenginepowered.com/tyconos-discovery-tool/

If the discovery tool won’t work for you, you can download from the internet a free IP scanner such as “Angry IP” or “Advanced IP Scanner”. These scanners will scan your network and show all devices connected to the network. The EZ-Bridge will show up as “Compex” in the network scan. Once you know the IP address, type it into a browser to open the EZ-Bridge control panel.

Please keep in mind that you can only open the control panel with a browser if your computer IP Address is on the same subnet as the EZ-Bridge. The subnet is the first 3 sets of numbers in the IP address: ie; 192.168.10.xxx


    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active Wifi and Lan interfaces. ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...

    • My EZ-Bridge was working but now it keeps dropping connection or performance has degraded. What could be the problem?

      If your system was working but now seems to be sluggish or it is dropping connection, the most likely culprit is that some new wireless device was added in your environment and there is wireless interference causing the issue. The EZ-Bridge ships ...

    • How to change the transmit channel on an EZ-Bridge Ultra?

      To Change transmitter frequency, open the Unit A Access Point Web Control Panel. Navigate to Wireless tab and change frequency to a fixed frequency rather than “Auto”. The Unit B Client will follow automatically after a few minutes.

    • How do I set up the EZ Bridge?

      EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and Play” Some package ...