How do I access the EZ Bridge’s Web Interface?

How do I access the EZ Bridge’s Web Interface?

You can access the EZ Bridge’s web interface by going to its IP address.

By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do not get an IP address, they automatically assign themselves the IP addresses found at the back of the antenna (192.168.1.139 for Unit A, 192.168.1.239 for Unit B).

You may use the EZ Bridge Discovery tool to find the antennas in your network. Any network scanning tool will work as well. Make sure you are using the appropriate discovery tool for your EZ Bridge.

  1. TyconOS Discovery Tool V2.6 for EZ Bridge LT+ and Dual-AC
  2. WISPOS Discovery Tool v1-3-5 for EZ Bridge LT
  3. Ultra Discovery Tool for EZ Bridge Ultra

Instructions on how to install the discovery tool can be found here:

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • Why can’t I open the EZ-Bridge® unit’s web page with my browser?

      Applicable Models: All EZ-Bridge Models To open the EZ-Bridge® web page with your browser you need to type in the IP address of the EZ-Bridge® into the address bar of a web browser (like Firefox, Chrome, etc.). Your computer must be on the same ...

    • How do I access the EZ-Bridge® to change settings?

      Applicable Models: All EZ-Bridge Models The EZ-Bridge® comes from the factory programmed to be plug and play. If the units are installed and powered up, they will automatically bridge the networks. If you want to change settings for any reason, you ...

    • How do I use the EZ-Bridge as a Wi-Fi access point?

      Applicable Models: All EZ-Bridge models If you need wireless access at the installation point: Start by making changes on the remote unit (Unit B). Switch the mode from “Station (WDS)” to “Station”. Do this by going to: Network >> Wi-Fi >> Edit >> ...

    • What changes are required to the EZ-Bridge setup to get the system up and running?

      Applicable Models: All EZ-Bridge models Please be aware that typically, no changes are required to get the units running and create a wireless bridge. Our EZ-Bridges are designed as plug-and-play units. All that is needed is to power the units up, ...