How critical is line of sight when using the EZ-bridge?
Applicable Models:
All EZBR models
With Wireless Bridges, a clear line of sight is always recommended. Any obstructions like trees, poles, fences, and buildings can block or reduce the power of a wireless signal. 5GHz is more sensitive to line of site issues while 2.4Ghz is more forgiving. Microwave signals travel in straight lines.
As they go through obstacles, they lose strength. When the signal strength gets too low (-80dBm), the receiver can’t perform well. If the distance between antennas is close, they can work well through obstacles but if the antennas are far apart, a single obstacle such as a tree can drastically effect performance. It is best to try it and see if the signal strength and performance are acceptable.
Tycon offers a 30-day money back guarantee so you can try the EZ-Bridge® in your application at no risk.
Related Articles
EZ-Bridge LT+ TyconOS Wiki
The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...
How do I access the EZ Bridge’s Web Interface?
You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...
How do I set up the EZ-Bridge-LT+?
Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...
How many IP Cameras can I use with my EZ-Bridge LT2+ or LT5+ wireless link?
Applicable Models: EZ-Bridge-LT+ EZ-Bridge-LT2+ EZ-Bridge-LT5+ The EZ-Bridge LT+ can support up to 100Mbps bandwidth. Normally people will see around 80Mbps due to RF interference or electrical noise or multi-path issues which cause packet retries ...
How can I connect two separate networks across an EZ-Bridge Ultra?
Applicable models: EZ-Bridge Ultra It is possible to have two separate networks connected through the EZ-Bridge Ultra You can have an EZ-Bridge Ultra connecting a network at the Local side with a network at the Remote side, using two routers, one ...