How can I reset my TPDIN® product to factory defaults?

How can I reset my TPDIN® product to factory defaults?

TPDIN-Monitor-WEB: Hold down the reset button while powering up the TPDIN-Monitor-WEB and hold for 15 seconds then release reset button. This should set the unit back to factory defaults.

Note: Resetting to factory defaults doesn’t affect the IP address settings.

-TPDIN-Monitor-WEB2 and the TPDIN-Monitor-WEB3:

  • Power up the unit. Wait at least 20 seconds. Press the reset button and hold for 10 seconds to reset to factory defaults.
  • If the reset button is held for longer than 30 seconds, the unit will roll back to the last stable factory firmware.
  • Only use this if the unit has an unrecoverable error.

TPDIN-SC48-20:

  • There is a button on the top of the controller labeled FACTORY DEFAULT.
  • Pressing and holding this button for over 5 seconds will reset to factory defaults.

    • Related Articles

    • I cannot send email from my TPDIN® series product!

      Following are the existing TPDIN products and what type of SMTP they support: TPDIN-Monitor-WEB Non SSL – Port 25 TPDIN-Monitor-WEB2 Non SSL – Port 25 ; SSL – Port 465 TPDIN-Monitor-WEB3 Non SSL – Port 25 ; TLS – Port 587 TPDIN-SC48-20 V1 Non SSL – ...

    • How can I change my TPDIN-Monitor-WEB2 relays to Normally Closed (NC)

      Unofficial hack. Note: This is an unofficial hack. Do this at your own risk. You can change the CH3 and CH4 relays to Normally Closed by changing the position of a soldered jumper wire inside the unit. Open the unit by removing all screws. Unsolder ...

    • Communicating with TPDIN-Monitor-WEB via TELNET

      NOTE: This only works with the original TPDIN-MONITOR-WEB. It is not implemented in the newer TPDIN-MONITOR-WEB2. You can use the ability of telnet to connect to the TPDIN-Monitor-WEB TCP port and use the HTTP interface to control the unit. Connect ...

    • How many characters for username and password in the TPDIN® products?

      TPDIN-Monitor-WEB: username and password fields on the Network Page accept up to 10 characters. TPDIN-Monitor-WEB2: username and password can accept up to 20 characters. TPDIN-Monitor-WEB3: username and password can accept up to 24 characters. ...

    • Email Setup for the TPDIN-SC48-20 V3

      Gmail: Create an App Password in your Google account: Go to your Google Account. Select Security. Under "Signing in to Google," select 2-Step Verification. At the bottom of the page, select App passwords. Enter a name that helps you remember where ...