How can I determine if my EZ-Bridge antenna system is working?

How can I determine if my EZ-Bridge antenna system is working?

Applicable Models:
All EZ-Bridge models

There are different ways on checking if your EZ Bridge is working. After following the instruction manual on setting up the EZ Bridge, you may check if the EZ Bridge is working by:

  1. Checking the LED lights at the bottom of the antenna, if the antennas are linked to each other, you would see this LED pattern: Green, Green(off/blinking), Red, Amber, Green, Green.
  2. You may also connect a computer with its Wi-Fi shut off to antenna B and check for internet connectivity. If you have internet, it means the EZ Bridge is working.
  3. Another way is to run the TyconOS Discovery tool on a computer that is either connected to the same router as Antenna A or Antenna B, if you see both antennas, then it means the EZ Bridge is working. https://tyconsystems.com/tycon-support/tycon-firmware/

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • My EZ-Bridge was working but now it keeps dropping connection or performance has degraded. What could be the problem?

      Applicable Models: All EZ-Bridge models If your system was working but now seems to be sluggish or it is dropping connection, the most likely culprit is that a new wireless device was added to your environment and there is wireless interference ...

    • What changes are required to the EZ-Bridge setup to get the system up and running?

      Applicable Models: All EZ-Bridge models Please be aware that typically, no changes are required to get the units running and create a wireless bridge. Our EZ-Bridges are designed as plug-and-play units. All that is needed is to power the units up, ...

    • How do I set up the EZ-Bridge-LT+?

      Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...