Do I need to be an engineer or technical person to install and operate the EZ-Bridge?

Do I need to be an engineer or technical person to install and operate the EZ-Bridge?

Applicable Models:
All EZBR models

The EZ-Bridge® is plug and play with no setup required. If you can install a wireless router or computer peripheral, you should have no problem with the EZ-Bridge.

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How many IP Cameras can I use with my EZ-Bridge LT2+ or LT5+ wireless link?

      Applicable Models: EZ-Bridge-LT+ EZ-Bridge-LT2+ EZ-Bridge-LT5+ The EZ-Bridge LT+ can support up to 100Mbps bandwidth. Normally people will see around 80Mbps due to RF interference or electrical noise or multi-path issues which cause packet retries ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...

    • How do I connect an EZGO+ to my EZ-Bridge LT+?

      Applicable models: EZBR-LT+ EZBR-LT2+ EZBR-LT5+ EZGO+ EZGO-2+ EZGO-5+ There are 2 main requirements so you can have another receiver in your EZ-Bridge LT+ setup. Make sure the 2nd receiving antenna would be within a 35-degree beamwidth of the ...

    • How do I set up the EZ-Bridge-LT+?

      Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...