Can the EZ-Bridge® be used with VLANs?

Can the EZ-Bridge® be used with VLANs?

Products:
EZBR-0214+
EZBR-DUAL-AC
EZBR-5AC
EZBR-DUAL-AC+

The EZ-Bridge® creates a layer 2 bridge between two points. The EZ-Bridge® will pass all untagged VLAN packets. The EZ-Bridge is not compatible with VLAN Trunking or VLAN Tagged Frames.
The new TyconOS firmware supports assigning the bridge UI to a particular VLAN in the user interface.

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How do I set up the EZ-Bridge-LT+?

      Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...

    • How can I secure SSH and Telnet on the EZ-Bridge?

      Applicable Models: All EZ-Bridge models If you want to tighten the security of accessing the EZ-Bridge unit through a terminal program like SSH or Telnet, we recommend the following: Set the listening port to a custom port. Any port other than 22 or ...

    • How can I set up a repeater on an EZ-Bridge LT or LT+ running WISPOS software?

      Applicable Models: EZ-Bridge LT and LT+ Setting up a repeater is relatively easy. It is used when you have three or more units and the third unit cannot communicate well with the main Access Point, so you set up the intermediate unit as a repeater. ...

    • How do I access the EZ Bridge’s Web Interface?

      You can access the EZ Bridge’s web interface by going to its IP address. By default, the EZ Bridges are set as DHCP clients, meaning they will be assigned an IP address automatically by your router or DHCP server. If for any reason the EZ Bridges do ...