Can I Use the Second Ethernet Port to Link Two Separate Access Points Together?
Applicable Models:
All EZBR models
The two ethernet ports under the antenna can accept 12-24V PoE. They are used to power on the antenna. They will not provide any PoE out. The two ports also act like a switch. A device connected to the spare ethernet port will connect to the same network as the EZ Bridge antenna.
Related Articles
EZ-Bridge LT+ TyconOS Wiki
The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...
How do I set up the EZ-Bridge-LT+?
Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...
Can I have a router on both sides of the EZ-Bridge® link?
Applicable models: EZBR-0214+ EZBR-5AC EZBR-DUAL-AC EZGO-0214+ EZGO-5AC EZGO-DUAL-AC Yes, on the internet side of the link, the EZ-Bridge® would be connected to one of the LAN ports on the main router. On the remote side of the link the EZ-Bridge® ...
How can I connect two separate networks across an EZ-Bridge Ultra?
Applicable models: EZ-Bridge Ultra It is possible to have two separate networks connected through the EZ-Bridge Ultra You can have an EZ-Bridge Ultra connecting a network at the Local side with a network at the Remote side, using two routers, one ...
How many IP Cameras can I use with my EZ-Bridge LT2+ or LT5+ wireless link?
Applicable Models: EZ-Bridge-LT+ EZ-Bridge-LT2+ EZ-Bridge-LT5+ The EZ-Bridge LT+ can support up to 100Mbps bandwidth. Normally people will see around 80Mbps due to RF interference or electrical noise or multi-path issues which cause packet retries ...