Can I power your EZ-Bridge products from a standard PoE Switch?

Can I power your EZ-Bridge products from a standard PoE Switch?

Applicable models:
EZBR-DUAL-AC
EZ-Bridge LT+
EZ-Bridge HD
EZ-Bridge ULTRA

It depends on the model:
  1. EZBR-Dual-AC can be powered from a standard PoE Switch which is 48V PoE.
  2. The EZ-Bridge LT+, HD, and ULTRA require 15V to 24V Passive PoE
  3. The EZ-Bridge LT+, HD, and ULTRA ships with a 24V Passive PoE inserter.
The LAN port of this inserter can be connected to a PoE Switch if you like, it won’t damage anything.

Caution: Powering the EZ-Bridge LT+, HD, or ULTRA with 48VDC PoE will damage the unit

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How do I set up the EZ-Bridge-LT+?

      Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...

    • Can I power a second device off my EZ-Bridge-LT+?

      Applicable models: EZBR-LT+ The RJ45 connectors on the LT+ don’t have PoE output capability, but you can use a 5.5 x 2.1mm DC Plug Jumper to power up the second EZ-Bridge. Maximum 10W output @ 15-24V DC. Note: The EZ-Bridge requires much less than ...

    • Can the EZ-Bridge® be used with VLANs?

      Products: EZBR-0214+ EZBR-DUAL-AC EZBR-5AC EZBR-DUAL-AC+ The EZ-Bridge® creates a layer 2 bridge between two points. The EZ-Bridge® will pass all untagged VLAN packets. The EZ-Bridge is not compatible with VLAN Trunking or VLAN Tagged Frames. The new ...

    • How do I access the EZ-Bridge® to change settings?

      Applicable Models: All EZ-Bridge Models The EZ-Bridge® comes from the factory programmed to be plug and play. If the units are installed and powered up, they will automatically bridge the networks. If you want to change settings for any reason, you ...