Can I power a second device off my EZ-Bridge-LT+?

Can I power a second device off my EZ-Bridge-LT+?

Applicable models:
EZBR-LT+

The RJ45 connectors on the LT+ don’t have PoE output capability, but you can use a 5.5 x 2.1mm DC Plug Jumper to power up the second EZ-Bridge. Maximum 10W output @ 15-24V DC.

Note: The EZ-Bridge requires much less than 10W.

    • Related Articles

    • EZ-Bridge LT+ TyconOS Wiki

      The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active WIFI and LAN interfaces. ...

    • How do I set up the EZ-Bridge-LT+?

      Applicable Models: EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist: Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and ...

    • Can I power your EZ-Bridge products from a standard PoE Switch?

      Applicable models: EZBR-DUAL-AC EZ-Bridge LT+ EZ-Bridge HD EZ-Bridge ULTRA It depends on the model: EZBR-Dual-AC can be powered from a standard PoE Switch which is 48V PoE. The EZ-Bridge LT+, HD, and ULTRA require 15V to 24V Passive PoE The EZ-Bridge ...

    • How many IP Cameras can I use with my EZ-Bridge LT2+ or LT5+ wireless link?

      Applicable Models: EZ-Bridge-LT+ EZ-Bridge-LT2+ EZ-Bridge-LT5+ The EZ-Bridge LT+ can support up to 100Mbps bandwidth. Normally people will see around 80Mbps due to RF interference or electrical noise or multi-path issues which cause packet retries ...

    • How can I set up a repeater on an EZ-Bridge LT or LT+ running WISPOS software?

      Applicable Models: EZ-Bridge LT and LT+ Setting up a repeater is relatively easy. It is used when you have three or more units and the third unit cannot communicate well with the main Access Point, so you set up the intermediate unit as a repeater. ...