Are the EZ-Bridge systems shipped complete with everything I need?
Systems are shipped with everything that is needed except the mounting pole or tower and CAT5 cables (if needed to interconnect equipment). The systems ship with 2 antennas with pole mount brackets, Power Over Ethernet Power Supplies and instructions. The HD systems include a 75′ shielded outdoor CAT5 cable.
Related Articles
EZ-Bridge LT+ TyconOS Wiki
The information below is for EZ-Bridge® This information is used for the following models: EZBR-0214+; EZBR-DUAL-AC Status Overview The overview page contains link status information and other pertinent info regarding active Wifi and Lan interfaces. ...
How do I set up the EZ Bridge?
EZ-Bridge ®- LT+ Series Initial Set-Up Procedure and Checklist Thank you for choosing the EZ-Bridge® Wireless Antenna System. Each Antenna system is factory tested and pre-configured so that most applications are true “Plug and Play” Some package ...
What do I need to supply when installing the EZ-Bridge® system?
You will need CAT5/6 Ethernet cable to go between the Power Supply/PoE Inserter and the EZ-Bridge Antenna. Cable must have all 8 wires. If you purchase the HD EZ-Bridge system, 75′ outdoor shielded cables are included. We recommend shielded outdoor ...
Do I need to be an engineer or technical person to install and operate the EZ-Bridge?
The EZ-Bridge® is plug and play with no setup required. If you can install a wireless router or computer peripheral, you should have no problem with the EZ-Bridge.
Is it possible only to buy receiver end if I am already using EZ Bridge LT+ product?
Yes, it is possible. The second receiving antenna is what we call EZ Go+ There are 2 main requirements so you can have another receiver in your EZ Bridge setup. Make sure the 2nd receiving antenna would be within a 35-degree beamwidth of the ...